“UV–Creation” – Fast Acrylic Resin, 3 Minute UV Cure

����How to use ���� Clean the silicone mould or metal resin base with acetone/alcohol. If you are working with a metal mould base, place it on a film (a regular file/cover or our Shiny Shield film).If you want to colour the UV resin, then squeeze a small amount of resin onto the film and add a drop of dye or pigment to it, and mix well. Resin staining can even be done directly in a silicone mould or metal base. Don’t add too much dye! You can also mix sequins and other decorative elements into the resin at this stage. Smooth the resin with a toothpick or a thin spatula within the mould.Keep the UV lamp turned on at a distance of 1-2 cm from the product for 2-5 minutes, directing the light at the product.If the product has a width of more than 5 mm, it is necessary to turn the product over and continue exposure to UV rays for another 3 minutes, or to achieve the desired width by creating several layers. Each layer should be well dried.If the product remains slightly sticky, hold the flashlight longer or leave it in a dry, warm place for several hours until it dries completely.UV lamp copes with drying much better than a flashlight. ����Important!✔️It is recommended to work with the material using personal protective equipment: gloves, a respirator mask and protective glasses.✔️Store the product with the cap tightly closed in a dark and dry place out of the reach of children.✔️Work with the material by children under 18 years of age is allowed only in the presence of parents or other responsible persons and only when the child uses personal protective equipment for the skin, respiratory organs and eyes.