Instruction Manual: Mirca Abralon Pads Polishing Cream KitSafety PrecautionsWear protective gloves to avoid skin irritation.Use safety glasses and a dust mask when sanding.Work in a well-ventilated area.Step-by-Step Polishing GuideStep 1: PreparationClean the Surface:Ensure the resin surface is free from dust, debris, and grease.Use a soft cloth or isopropyl alcohol for cleaning.Inspect the Surface:Check for scratches, irregularities, or cloudy areas that need polishing.Step 2: SandingImportant: Always keep the pads and surface slightly damp during sanding to reduce heat and prevent dust.Start with the 500 Grit Pad:Gently sand the surface in a circular motion or back-and-forth.Apply light pressure; let the pad do the work.Wipe off the residue with a damp cloth.Repeat with Finer Grits (1000, 2000, and 4000):Move to the next grit only after the surface feels smoother.Continue sanding progressively to refine the finish.Step 3: PolishingApply the Polishing Cream:Place a small amount of ResinPro Polishing Cream onto a microfiber cloth or a buffing wheel.Spread it evenly over the surface.Polish the Surface:Use a circular motion to buff the surface.If using a buffing wheel, keep the speed low to medium.Continue until the surface becomes glossy and smooth.Wipe Off Excess Cream:Use a clean, dry microfiber cloth to remove residue.Step 4: FinishingInspect the surface under good lighting to ensure a uniform finish.If necessary, repeat the polishing step for extra gloss.Tips for Best ResultsKeep the pads damp but not soaking wet.Sand evenly without skipping grit levels for a smooth transition.Avoid over-polishing to prevent overheating or damage to the surface.Care and MaintenanceWash the Abralon pads after use with water and mild soap. Allow them to air dry.Seal the polishing cream tightly to prevent it from drying out.
