�� HOW TO USE. MIX RATIO BASED ON WEIGHT – 100:75Use adequate personal protective equipment.For best results, measure two components based on weight using a scale within 5% of the recommended mix ratio.Always mix the product thoroughly for at least 3 minutes, scraping all the surfaces of the container to ensure complete mixing.Try to use the product in a temperature-controlled environment within the optimal product specifications.Avoid high humidity or low ambient temperatures.Ensure that the surface is dry and any dirt, dust and oils removed to achieve optimal bonding. It is furthermore highly recommended to sand the surface (with sandpaper or mechanical preparation).Perform small preliminary tests to have a clear understanding of the polymerization features of the resins in your work environment and the compatibility of the resins with other materials.HEAT PRO is a transparent, two-component polyurethane resin, ideal for protecting your creations. Here are all the tips for correct application! It is very important to have the correct room temperature, above 20°C for all processing steps. Heat Pro must have a temperature above 20°C, so if you are not sure if the temperature is right, warm the cans slightly by keeping them in a warm place for at least a couple of hours.The product is ideal for application on small surfaces, not exceeding 0.25 square metres.Apply only to perfectly dry surfaces. Not compatible with acrylic or liquid dyes.The product must be applied as a final coat (1-3 mm) on a transparent resin surface (without dyes). Do not apply directly on wood, concrete and stone (unless first treated with transparent resin)If you want to apply on coloured resin or other materials, apply at least a 1 mm layer of clear resin beforehand.Wait 24-48h and apply Heat Pro. Use a heat source to eliminate bubbles however, be careful to pass the torch or hairdryer only briefly (max. 2 seconds) over each area to avoid damage to the finish.The special scratch and heat resistant finish will have a softer texture than classical resins: this specific texture will guarantee maximum performance!Your result will be perfect!WARNINGS: During processing, use protective masks, gloves, and other protective clothing. In case of contact with eyes, immediately rinse with cold water for 15 minutes and immediately consult a doctor.
